Aqua Metal Protection 3 in 1
Thick-layer metal protection paint for base, intermediate and final coating on iron and non-ferrous metals, stainless steel, hot-dip galvanized steel parts, powder-coated substrates coil coating and non-anodized aluminium. Suitable for use on steel frames, FH doors, trapezoidal sheet metal claddings, railings, drain pipes, metal constructions, sheet metal roofs with a minimum gradient of 5 %, etc. Metal protection 3 in 1 is hand-weldable therefore also suitable for areas that are touched more frequently.
Excellent adhesion. The use of special adhesion additives and anti-corrosive pigments results in double-acting corrosion protection. No rust protection primer required, quick-drying, very good edge coverage, optimum paint-over ability, no loosening of old coatings, weather-resistant, odourless.
Acrylate polymer dispersion
Degree of gloss
(23 °C 60 % rel. air humidity)
Dust dry after approx. 30 minutes. Dry to the touch after approx. 2 – 3 hours. Ready for overcoating after 5 – 6 hours. Ultimate hardness: is reached after approx. 7-10 days!
6 - 8 m²/l per coat
Type of application
Brushing: Use water-based paint brush for brushing. Rolling: Use short pile (approx. 11 mm) microfibre mix for rolling. Spraying: see Technical Information Sheet.
Without iron mica:
White and Jansen MIX.
Note for use as sheet metal roof paint and large-surface metal surfaces outdoors: Special colours and intensive colours from 60 l (in 10-litre containers) as factory production upon request.
With iron mica:
DB 701, DB 702 (approx. RAL 9007), DB 703, RAL 9006, copper scrap and Jansen MIX.
The thixotropy allows a very high dry film thickness on vertical surfaces and edges. This protective property can result in a surface with more or less structure when applied to larger surfaces, depending on the processing method and processing conditions. This can be minimized by using Additive SRS (see technical data sheet).
Field of application
750 ml, 2.5 l, 5 l*
*5 l only in white, DB 703 and RAL 9006